Step
Step 24
å
Unfold the LARGE BACK (R) and lay it over the upper portion of your unit.
å
Make equal margins along all four edges of the LARGE BACK (R). Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the sides and top edges of the LARGE BACK (R) to your unit using the NAILS (1N).
å
NOTE: Also, be sure to tap NAILS (1N) into the holes that line up over the HUTCH UPRIGHT (G) and SHELVES (P and Q).
å
NOTE: Do not tap nails into the bottom edge of the LARGE BACK at this time.
å
Position the BACK (S) over the lower portion of your unit, making equal margins along four edges of the BACK.
å
NOTE: The BACK (S) will overlap the LARGE BACK (R) as shown in the enlarged diagram.
å
Fasten the BACK (S) and lower edge of the LARGE BACK (R) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS (1N) into the holes that line up over the SMALL UPRIGHT (F).
å
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
NAIL
(80 used in this step)
1N
Unfi
nished
sur
face
Do not fasten NAILS along
this edge until the BACK (S) is
overlapping the LARGE BACK (R).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
R
The BACK (S)
overlaps the
LARGE BACK (R).
S
R
S
Unfi
nished
sur
face
Fasten the top and side edges
of the LARGE BACK (R) fi rst.
These holes must line up over
the HUTCH UPRIGHT (G) and
SHELVES (P and Q).
These holes must
line up over the
SMALL UPRIGHT (F).
420410
www.sauder.com/services
Page 29
