Step 4
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the LEFT END (B) and UPRIGHT (C).
Use eight SILVER 1/2" FLAT HEAD SCREWS (15).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the END and
UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Open end
Open end
Open end
1
1
1
1
C
B
Page 8
SILVER 1/2" FLAT HEAD SCREW
(8 used in this step)
15
Push up on the black lever and pull the SLIDE from the RAIL.
2
1
