å
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into the END (A) until the shoulders of the SCREWS rest on the surface
of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDING (K) onto the END (A). Line up the grooves in the MOLDING over the heads of the SCREWS in
the END.
å
NOTE: The MOLDING should be even on both edges of the END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Slide the MOLDING (L) onto the END (A) until it comes into contact with the MOLDING (K).
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Repeat this step for the remaining END.
Step 12
A
L
K
BLACK 9/16" FLAT HEAD SCREW
(12 used in this step)
32S
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
Sur
face with
less holes
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
426135
www.sauder.com/service
Page 18
