Step
Step 17
å
Carefully turn your unit over onto its front edges. Unfold the
BACK (L) and lay it over your unit.
å
A perforation in the BACK (L) has been provided for access
to the SAFETY STRAP. Punch out the perforation and push
the SAFETY STRAP through the hole.
å
Make the bottom edge of the BACK (L) even with the
bottom edge of the BOTTOM (F). Then, make equal
margins along the side edges of the BACK (L). Push on
opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (L) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHT (E).
å
Peel the FELT DISC from the FELT DISC CARD (1M). Stick a
FELT DISC on the bottom of each LEG (B, C, and D).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
These holes must line up
over the UPRIGHT (E).
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
NAIL
(44 used for the BACK)
1N
L
1M
B
B
C
C
D
F
422893
www.sauder.com/service
Page 22
Safety strap
