www.sauder.com/services
9
404958
-
Carefully turn your unit over onto its front edges. Unfold the BACKS (R and S) and lay them over your unit.
-
Make equal margins along all four edges of the BACKS (R and S). Push on opposite corners of your unit if needed to make
it “square”.
-
Fasten the BACKS (R and S) to your unit using the NAILS (RR).
NOTE:
Be sure to tap NAILS into the holes that line up over the UPRIGHTS (C and D).
NOTE:
Perforations have been provided for access through the LOWER BACK (S). Carefully cut out the rectangle for proper
ventilation of your CPU.
NAIL
(48 used in this step)
RR
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
S
R
Unfinished
surface
These holes must line up
over the UPRIGHTS.
Cut--out
