-
Position the
DRAWER UPRIGHT (C)
and
DRAWER END (B)
as shown with the unfinished surfaces facing up.
NOTE:
Be sure the flat edges of the DRAWER UPRIGHT and DRAWER END are facing as shown.
Follow the diagram closely.
-
Fasten both
LONG LEFT CABINET RAILS (Z)
to the
DRAWER END (B).
Fasten both
LONG RIGHT CABINET
RAILS (Y)
to the
DRAWER UPRIGHT (C).
Use two
5/16” FLAT HEAD SCREWS (DDD)
through the first and second
holes from the roller in each
RAIL
and into the pre--drilled holes in the
DRAWER END
and
DRAWER UPRIGHT.
NOTE:
The CABINET RAILS are marked “CABINET RIGHT” and “CABINET LEFT” for easy
identification. Be sure the roller end of each RAIL is positioned toward the flat edges of the
DRAWER END and DRAWER UPRIGHT. Follow the diagram closely.
-
Fasten the
SHORT LEFT CABINET RAIL (DD)
to the
DRAWER END (B).
Fasten the
SHORT RIGHT CABINET
RAIL (CC)
to the
DRAWER UPRIGHT (C).
Use two
5/16” FLAT HEAD SCREWS (DDD)
through the first and second
holes from the roller in each
RAIL
and into the pre--drilled holes in the
DRAWER END
and
DRAWER UPRIGHT.
NOTE:
Be sure the roller end of each RAIL is positioned toward the flat edges of the DRAWER END and
DRAWER UPRIGHT. Follow the diagram closely.
11
1034--290D
DRAWER
UPRIGHT (C)
DRAWER
END (B)
Roller
end
Roller
end
5/16” FLAT HEAD SCREW (DDD)
(12 used in this step)
Roller
end
Roller
end
SHORT LEFT
CABINET RAIL (DD)
SHORT RIGHT
CABINET RAIL (CC)
LONG LEFT
CABINET RAIL (Z)
LONG RIGHT
CABINET RAIL (Y)
DRAWERS ON THE LEFT
Unfinished
surface
Unfinished
surface
Flat edge
Flat edge
Use this hole.
1--800--523--3987
Customer Service
