8
9
EXCELLENCE SE-400
EXCELLENCE SE-400
1. Do not operate the vacuum cleaner too close to heaters, radiators, and
other hot surfaces.
2. Before inserting the plug into the wall, make sure your hand is dry.
3. Before turning on the vacuum cleaner, remove any large or sharp objects
from the floor or cleaning surface in order to prevent damage to the filter.
4. When you want to pull the plug from the wall, do not use the power cable,
gently pull the plug from the power socket.
5. If the air inlet, floor head or telescopic tube are blocked, you should switch
off the cleaner straight away and remove from mains power supply. First clear
the blocked substance before attempting to start the vacuum cleaner again.
Please do not expose the electrical hose to water or clean it with water. Damaged
cables should be inspected by an authorized Sauber service representative. Do not
use the machine with damaged cables.
Important instructions for use of a powerhead
Leaving the machine in a stationary position for an extended period of time while the
brush roller is spinning may cause damage to your floor or carpet. Be sure not to allow
carpet edges or fringe into the brush. As with any vacuum with a rotating brush, this
machine could cause damage to loosely woven carpets or rugs, wool loop carpets,
long-piled carpets, or very soft, sensitive floor coverings. Please use the combination
head for the above mentioned floorings. We do not recommend the use of the
powerhead for cleaning old and especially valuable hand-crafted carpets. If you have
uneven flooring, the metal part underneath the machine may come in contact with the
floor, causing scratches. Please carry the machine across high thresholds.
Before You Begin
Open the shutter
and gently push
the powered hose
in the opening.
Connect the
electronic control
handle to the
telescopic tube.
Connect the
telescopic tube
to the Powerclean
head (ET1).
To extend the length
of the telescopic tube
slide the lock down.
To reduce the
extension, slide
the lock up.
1
2
3
4
Assembly
The cleaner should be switched off and disconnected from the
mains power supply before you start to assemble.
Gently pull out the
power cable and
connect it to the
power socket.
5
Switch on
the vacuum
cleaner, from the
electronic control
handle or from the
vacuum cleaner.
6
Switch on/off the
Powerclean head
by pressing on
the brush button
on the electronic
control handle.
7
WARNING!
DRY USE ONLY. Do not use in wet conditions.
