5
Names of Components
Main Unit
①
Display
Section
Measured values and state of the main unit are displayed.
* Refer to “LCD Display” for details
②
POWER
On/off key
③
HOLD
Press this key to hold a measured value shown on the LCD. Press
the key again to release it.
④
MN/MX/RST
In measurement mode, press this key to display the minimum or
maximum value. Press it for 2 seconds to reset the values.
⑤
SET
Use this key to set the alarm or wind speed.
In WBGT mode, press it for 2 seconds to enter the alarm setting
mode. In globe temperature mode, press the key for 2 seconds to set
the wind speed. After changing them press the key again for 2
seconds to fix the value and return to measurement mode.
⑥
IN_OUT/Next Press this key for 2 seconds in WBGT mode to set WBGT measuring
ambient to either indoor (IN) or outdoor (OUT).
In alarm setting mode, press it to change the focused place value to
be edited.
In wind speed setting mode, press the key to decrease the value.
⑦
MODE/Up
In measurement mode, press this key to switch between each mode
of WBGT index (WBGT), air temperature (TA), globe temperature
(TG), or humidity (RH).
In alarm setting mode or wind speed setting mode, press the key to
increase the value.
RS232C
Cable Jack
Buzzer
Speaker
Battery
Compartment
Hole for
Tripod
