6
(2) Remove the four M3 screws from the back of the unit case.
- Do not loosen or retighten the screws other than the four shown in the figure below.
Back view
(3) Align the screw holes on the hanging brackets with the screw holes on the unit, and then secure it
with the M3 screws removed in step (2) above.
- Make sure that the upper part of the bracket to be secured to the ceiling and the unit
panel are facing the same direction as shown in the figure below on the right.
- Be sure to use the M3 screws removed from the unit.
Back view
●
Connecting the cable
Remove the screws from the terminal cover to take out the cover.
- Break the film covering the cable opening at the bottom of the unit case.
- Draw the connection cable and the cable of the AC adapter through the cable opening, and then
connect them to the terminals on the terminal block.
- Use a cable of an appropriate size.
- It is recommended to use a crimp-style terminal; tighten it securely.
- Upon completion of connecting, be sure to install the terminal cover.
- To install the terminal cover, first hook the tab of the lower cover into the bottom edge of the terminal
opening on the unit case, and then secure the terminal cover with the mounting screws.
- Be sure to use the M3 screws removed from the unit.
DC jack
cable opening
terminal block
terminal opening
on the unit case
terminal cover
cable opening
Screw for terminal cover