9
How to Use
Cautions
- No power switch is available for this instrument, therefore the instrument becomes its operation state
when connected to a power source.
- Connect to a power source only after completing the wiring.
- Please be careful not to confuse the wiring. Incorrect wiring may result in instrument failure.
- Do not touch the terminals while power is being supplied.
- Please use the input load within the standard specifications.
- Remove all electrical wirings before moving the instrument. Fail to do so may cause dropping of the
instrument.
- Make sure to select a proper type of AC adaptor in accordance with related standards and product
specifications when not using the accessory device that comes with the instrument.
- Make sure to put the terminal cover on during usage time in prevent from dust or an electric shock.
- Input a direct current with the range from 4 to 20 mA. Using the instrument outside of its range may
cause instrument failure.
1. AC adaptor
Please select an adaptor which meets following specifications when using another adaptor that was not
included in the instrument.
<Primary output>
Voltage
: DC12V
Electrical Current : 1A
Polarity
:
Plug diameter
: outer diameter ø5.35mm, inner diameter ø2.1mm, length 9.25mm
2. How to use
(1) Check for the correct wiring and secure fixture of the instrument.
Refer to the 'Wiring method' and 'Installation method' sections of this manual for proper wiring and
secure installation.
(2) Insert the AC adaptor plug into DC jack from
the AC adaptor outlet.
The LED on the display will light up and the
instrument is in operation.
(3) In order to finish the operation, pull out the AC adaptor from DC jack. The display will turn off and the
operation is ended.
