10
Installer Manual
SATEL
ASD-200
- wireless smoke and heat detector.
ASD-250
- wireless smoke detector.
AXD-200
- wireless multipurpose detector, which can work as:
AFD-200
- water flood detector,
AMD-200
- magnetic contact,
AMD-201
- dual channel magnetic contact,
AMD-202
- magnetic contact with input for roller shutter detector,
ARD-200
- reorientation detector,
ATD-200
- temperature detector,
AVD-200
- shock detector and magnetic contact.
Sirens
ASP-215
- wireless indoor siren.
Hardwired zone / output expanders
ACX-210
- miniature hardwired zone / output expander.
ACX-220
- hardwired zone / output expander.
Controllers
ASW-200
- smart plug.
ASW-210
- flush-mounted wireless two-channel 230 V AC controller.
Other devices
APB-200
- wireless panic button.
5. System installation
Disconnect power before making any electrical connections.
The following tools will be useful during installation:
•
blade screwdriver 2.5 mm,
•
Phillips screwdriver,
•
precision pliers,
•
flat nose pliers,
•
driller c/w a set of drill bits.
5.1 Installation plan
The installation must be preceded by preparation of a plan of the security alarm system. It is
advisable to draw up a sketch of the premises and mark on it all the devices that are to be
included in the alarm system: control panel, keypads, detectors, sirens, expansion modules
etc. When planning the installation location for the control panel and ABAX 2 / ABAX wireless
devices, you must take into consideration the range of radio communication. Remember that
thick masonry walls, metal partitions, etc. will reduce the range of radio signal. The control
panel and other alarm system components should be installed within the protected area.
When writing data to FLASH memory and when the STARTER program is running
(control panel firmware is being updated), the expander outputs are deactivated. The
status of the control panel mainboard outputs remains unchanged. Keep that in mind
when designing the system. It is recommended that devices whose operation must not
