4
INT-TSI
SATEL
Installation of the keypad working in SLAVE mode
1. Open the keypad enclosure (Fig. 1). The enclosure opening tool is included in the keypad
delivery set.
2. Place the enclosure base against the wall and mark the location of mounting holes.
3. Drill the holes for wall plugs (screw anchors).
4. Install in the wall a junction box in which you will place the ferrite ring. Make sure it is
placed as close as possible to the keypad.
5. Wind the cables around the ferrite ring (Fig. 2), but no more than 3 turns per cable.
6. Place the ferrite ring inside the junction box.
7. Pass the cables through the opening in the enclosure base.
8. Using wall plugs (anchors) and screws, secure the enclosure base to the wall. Proper wall
plugs must be selected for the type of mounting surface (different for concrete or brick
wall, different for plaster wall, etc.).
9. Connect the power wires to the +12V and COM terminals. The keypad can be powered
from the control panel, from an expander with power supply or from an additional power
supply unit.
The INT-TSI keypad cannot be powered from the +KPD output of the INTEGRA 24,
INTEGRA 32 and INTEGRA 128-WRL control panels. Use the OUT1 or OUT2 output
programmed as “41. Power supply”.
A function is available in the keypad that allows you to check if the keypad is properly
powered (see the INT-TSI keypad user manual).
10. Connect the keypad to the Ethernet. Use a cable compliant with the 100Base-TX
standard (same as used for connecting computer to the network). The cable must have
the RJ-45 plug. It is recommended to use the flat network cable, because it is more
flexible. Secure the cable using a cable tie (Fig. 4).
11. Place the front panel onto the catches and snap close the enclosure.
12. Turn the power on and activate the SLAVE mode (see the full installer manual).
The declaration of conformity may be consulted at www.satel.eu/ce
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND
tel. +48 58 320 94 00
www.satel.eu
