Satel INT-TSG, Руководство по установке, Страница: 9 / 28

SATEL INT-TSG 7
1. Open the keypad enclosure (see: Fig. 1).
2. Insert the card into its slot (see Fig. 3) and push until it clicks into place. The card contacts
should be directed toward the display.
3. Close the keypad enclosure.
6.2 Removing the microSD card
1. Open the keypad enclosure (see: Fig. 1).
2. Push the card to release it.
3. Remove the card from its slot.
7. Keypad configuring
7.1 Keypad connected to INTEGRA / INTEGRA Plus control panel
To configure the keypad settings you can use:

D
LOAD
X program:  “Structure” window  “Hardware” tab  “Keypads” branch 
[keypad
name]
. The D
LOAD
X program alone makes it possible to configure all the settings.

LCD keypad:  S
ERVICE MODE
 S
TRUCTURE
 H
ARDWARE
 LCD
KEYPADS
 S
ETTINGS

[keypad name]
. How to enter the service mode, refer to the section on programming
keypad address by means of the service function (p. 4).
7.1.1 Keypad
Shown in square brackets are the names displayed on keypads.
Name
– individual name of the keypad (up to 16 characters).
Partitions managed by keypad
[Partitions] – the partitions which can be armed/disarmed or
alarm in which may be cleared from the keypad. These functions are available to the users
having a suitable authority level and access to those partitions.
Using the service code you can operate all partitions, irrespective of which partitions
are operated by the keypad.
Show alarms of partitions
[Alarms] – the keypad can signal burglary alarms from selected
partitions.
Show fire alarms of partitions
[Fire alarms] – the keypad can signal fire alarms from
selected partitions.
CHIME signal of zones
[Chime zones] – the keypad can audibly signal violation of selected
zones. If the zone is armed, violation will not trigger the CHIME signal.
Zone disabling CHIME
[Chime bps. zone] – zone, which, if violated, will disable the CHIME
feature for specified time.
Bypass time
[Chime bps. time] – time during which the CHIME signal will be disabled after
violation of the zone which disables the signaling (time is counted from the zone restore). If
the value 0 is programmed, the signaling will not be disabled.
Quick Arm partitions
[Quickarm part.] – partitions which can be armed without entering the
code (quick arming).
Show entry delay of partitions
[Entry time p.] – the partitions, for which counting the entry
delay will be indicated by text appearing on the display.
Show exit delay of partitions
[Exit time part.] – the partitions for which counting the exit
delay will be indicated by text appearing on the display.