SATEL GPRS-T6
11
a telephone whose number is stored in the module memory in the list of telephone
numbers for messaging.
Initiating SMS
– a code which must be included in the SMS message sent to the module
GSM telephone number, so that the module can make an attempt to connect to
the computer whose IP address and communication port are indicated in the SMS
message.
GSM telephone
PIN
– SIM card PIN code (if the card requires entering the PIN code).
Entering invalid PIN code may result in blocking the SIM card.
SMS center number
– telephone number of the Short Message Service Center, which
delivers SMS messages. If the number has been written by the operator to the memory of
SIM card installed in the device, it need not be entered. In such a situation, the module will
download it automatically. Otherwise, it is necessary to enter the number, if the module is
to send SMS messages. It should be remembered that the number written into the module
must be suitable for the network in which the SIM card is registered.
GPRS APN
– Access Point Name for Internet GPRS connection.
User
– user name for Internet GPRS connection.
Password
– password for Internet GPRS connection.
APN, user name and password must be defined, if GPRS data transmission (event
codes, programming) is to be available.
DNS server
– DNS server IP address which is to be used by the module. The DNS server
address is necessary when GPRS technology is used for sending data, if the address of
the device to which the module is to connect (monitoring station, computer with
GPRS-S
OFT
program) has been entered as a name. If all addresses are given in the IP
address form (4 decimal numbers separated by dots), programming the DNS server
address is not required.
Other
USSD codes forwarding message
– content of the control command that must precede the
USSD code in SMS message being sent to the module. The USSD codes make it possible
e.g. to check the account status of SIM card installed in the module. The form of SMS
message must be:
xxxx=yyyy=
, where “xxxx” is the control command, and “yyyy” – the
USSD code served by the operator of GSM network in which the telephone is used
(it depends on the SIM card installed in the module). Having received such an SMS
message, the module will execute the USSD code contained therein. The answer received
from the operator is sent in the form of SMS message to the telephone number from which
the control command was sent.
Using the advanced functions available due to the USSD service (when menu is
presented in reply to the code entered) is not recommended.
Autorestart every
– if the restart of module settings is to be periodically repeated, you must
define every how many hours it is to happen. The first restart of module settings will occur
after the programmed time has elapsed since the settings were written to the module. If 0
is entered, the function will be disabled.
Limit number of notifications to
– this field allows you to specify the maximum number of
transmissions (GPRS, SMS messages, CLIP service) sent by the module during 24 hours.
The test transmissions and SMS messages with information on module status are not
included in the number of transmissions and are not limited. Values from 0 to 255 can be
entered. Entering 0 means no transmission limit (default: 0).
