SATEL AMD-102
3
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the
battery.
The used batteries must not be discarded, but should be disposed of in accordance
with the existing rules for environment protection.
The device is designed for indoor installation. The detector should be mounted on a fixed surface
(e.g. window or door frame), and the magnet on a movable surface (e.g. window or door).
Mounting the magnetic contact on ferromagnetic surfaces and/or near to strong magnetic and
electrical fields is not advisable, because it can result in malfunctioning of the device.
1. Open the detector enclosure (Fig. 2).
2. Install the battery and add the device to the wireless system (see the ABAX controller manual
or the INTEGRA 128-WRL / VERSA / VERSA Plus / VERSA IP control panel installer
manual). The sticker with serial number which shall be entered when registering the detector
in the system can be found on the electronics board.
3. Close the detector enclosure.
4. Fasten the detector temporarily at the place of its future installation.
5. Check the level of signal received from the detector by the ABAX controller or the
INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select another place
for installation. Sometimes, it is sufficient to shift the device ten or twenty centimeters to
obtain a considerable improvement in the signal quality.
6. Open the detector enclosure (Fig. 2).
7. Make a hole in the enclosure base and run through it the wires for roller shutter detector
and/or NC type detector (the maximum permissible wire length is 3 meters).
8. Use screws to fix the enclosure base to the mounting surface (Fig. 4). Wall plugs (screw
anchors) and screws are included in the detector delivery set.
