SATEL
ACX-200
3
5. Check the level of signal received by the controller from the expander. Change the
place of installation, if necessary.
6. Having obtained the optimum signal level, install the expander permanently.
7. Connect the tamper contact to one of the expander zones. Program this zone as
the tamper zone. You can also connect the tamper contact in series with a 2EOL
configured device (detector), connected to one of the expander zones.
8. Connect the wire devices to the expander zones and outputs.
Note:
The cables (for power supply, connection between the expander and hardwired
devices, etc.) should not be run in the immediate vicinity of the antenna, since it
may cause radio interference.
9. Close the housing.
10. Configure the expander zones as required. For information related to configuration
of the ACX-200 expander, please refer to the ACU-100 controller user manual.
3. Technical data
Working frequency band............................................................. 868.0MHz ÷ 868.6MHz
Range .....................................................................................up to 150m (in open area)
Rated supply voltage ................................................................................ 12V DC ±15%
Average current consumption (depending on relay status).................... 40mA ÷ 120mA
Current-carrying capacity, relay outputs............................................................ 1A / 24V
Working temperature range..........................................................................0°C...+55°C
Housing dimensions, OPU-1 A.............................................................. 126x158x32mm
