8 ACU-270
SATEL
The less often communication between the controller and the wireless devices takes
place, the lower energy consumption and the longer battery life are.
In the case of the AMD-103 detector and ASP-100 siren, no communication takes
place during polling.
Higher sensitivity for jamming detection
– if this option is enabled, the sensitivity of
detection of radio communication jamming is boosted.
Synchronize
– this function starts the procedure of synchronization, i.e. checking for
presence of other ABAX wireless system controllers working within the controller operating
range. The controller will synchronize the response period so that the radio transmissions
of some controllers should not be mutually jammed. Synchronization is performed
automatically upon starting the controller and after each operation of adding/removing
devices supported by it.
Test mode
– in the ABAX system the test mode can be started, in which:
– LED indicators are enabled in the wireless devices (the LEDs are disabled during
normal operation) – information provided by means of the LEDs depends on the device;
– signaling is blocked in the ASP-105 and ASP-205 sirens.
The test mode is started/ended during polling, which results in a delay, its duration
depending on the programmed response period. The test mode will be turned off
automatically after 30 minutes of:
– starting the test mode from the DLOADX program (the 30-minute period is running from
the moment of exiting the controller settings),
– exiting the service mode in the control panel.
According to requirements of the EN50131 standard, the level of radio signals sent by
wireless devices is reduced during the test mode operation.
For the AMD-103 detector, entering the test mode remotely is not possible.
6. Wireless devices
The wireless keypads constitute a special category of devices and therefore they are
discussed in a separate section.
6.1 Wireless devices supported by the controller
Detectors
AFD-100 – wireless water flood detector.
AGD-100 – wireless glass-break detector.
AMD-100 – wireless magnetic contact.
AMD-101 – dual channel wireless magnetic contact.
AMD-102 – wireless magnetic contact with input for roller shutter detector.
AMD-103 – wireless magnetic contact.
AOD-200 – wireless outdoor dual technology motion detector.
APD-100 – wireless passive infrared detector.
APMD-150 – wireless dual technology motion detector.
ARD-100 – wireless reorientation detector.
ASD-110 – wireless smoke and heat detector.
