SATEL
ADD-200
5
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
Be particularly careful during installation and replacement of the battery.
The manufacturer is not liable for the consequences of incorrect installation of
the battery.
The used batteries must not be discarded, but should be disposed of in
accordance with the existing rules for environment protection.
The figures below only show the detector installed vertically, but the detector may be installed
in any position (position of the detector has no effect on the operation of the sensors).
1. Install the battery and add the detector to the wireless system (see ABAX 2 controller
manual). The sticker with the serial number required for registration of the detector in the
system can be found on the electronics board.
If the ABAX 2 controller is connected to the VERSA series control panel, add and
configure the ADD-200 detector using the DLOADX program.
2. Press the gasket (included with the detector) into the groove of the enclosure cover.
The gasket must fill the entire groove, so that both of the gasket ends touch each other
(Fig. 3). Do not shorten the gasket
– it is fitted to the length of the groove.
It is recommended that the ends of the gasket are situated on the bottom of the
enclosure after the cover is replaced.
3. Replace the cover and fasten it to the enclosure base with 4 screws (Fig. 4).
4. Place the detector at the location of its future installation.
5. Check the level of signal received from the detector by the ABAX 2 controller. If the signal
level is lower than 40%, select another place for installation. Sometimes, it is sufficient to
shift the device ten or twenty centimeters.
The ARF-200 tester allows you to test the level of radio signal at the location of future
installation without having to place the detector on-site.
6. Use screws to secure the enclosure base to the mounting surface. Select appropriate wall
plugs based on the type of the mounting surface (different for concrete or brick wall,
different for plaster wall, etc.).