Satec PRO PM335 Скачать руководство пользователя страница 4

Страница: 4 / 4

PRO PM335 QuickStart

www.satec-global.com

CONNECTING OPTIONAL SATEC MODULES

DO NOT HOT-SWAP. When adding modules, make sure the unit is disconnected from

power supply

Remove cover (sticker on right side of unit) to reveal port

Attach the module tightly and tighten the clips

Power on the unit

GENERAL INFORMATION AND SYSTEM DEFAULTS

Default password: 9

Default IP: 192.168.0.203 (ETH1)

Default current mode (HACS model): Alternating Current (AC)

Default serial com settings (RS485): 19,200 Baudrate; address = 1

For convenient configuration please use SATEC’s PAS engineering software, connecting

your PC to the USB port (type C) at the right side of the front panel

To download PAS (free):

make sure to update .exe file with the most recent update available on webpage

Содержание PRO PM335

Страница 1: ...se visit our website www satec global com Warning Only a licensed electrician may perform installations and wiring of the PM335 Figure 1 PM335 front panel INSTALLATION The PM335 is designed for 4 inch...

Страница 2: ...s 14 AWG minimum pole to the device s I1 current input unit s bottom right of rear end as in figure 2 and the pole to the adjacent I1 current input Repeat this for the following two phases I2 and I3 V...

Страница 3: ...pushbuttons figure 1 front panel When powered on the device will default to displaying voltages for basic setup back up button to the home screen navigate with arrows to setup select with enter defau...

Страница 4: ...AND SYSTEM DEFAULTS 1 Default password 9 2 Default IP 192 168 0 203 ETH1 3 Default current mode HACS model Alternating Current AC 4 Default serial com settings RS485 19 200 Baudrate address 1 5 For c...