17
2.
“Settings range for the logic generator” –
here you can set the
range of set points that will be used on the PM180 device, during
automatic logic generation. For detailed information see
3.11.
3.5
Main function block
A newly created device contains one function block named MAIN.
Figure 23 - Main function block
Main function block must be in every device. This block is sent to the
device when you use function “Send configuration to the device”
(see
3.8.2).
If you don’t have main function block in your device you will get
an error (see
4.3).
Note that if you add new function blocks to the device (see
3.6) you
have to use them in the Main function block otherwise that logic will be
ignored during uploading procedure.
3.6
Adding function blocks
To add additional function (FB) block do the following:
1.
Click the right mouse button on the section “Programmable logic”
of the device and choose “New function block”.
Figure 24 - Add new function block
2.
A new block
named “POU”
will appear in the project tree.
Содержание Expertmeter PM180
Страница 21: ...21 Figure 29 Input variables mapping ...
