SATA spray master RP, Руководство по эксплуатации

Страница: 509 / 521

528
US
SATA spray master RPOperating Instructions
9. Maintenance and Repair
Warning!
Risk of injury from sudden component separation or escaping
material.
If the compressed air circuit supply is not disconnected before perform-
ing maintenance work, components can detach and/or material escape
unexpectedly.
→ Disconnect the paint spray gun from the compressed air circuit before
performing any maintenance work.
Warning!
Risk of injury from sharp edges
When performing assembly work on the nozzle set, there is a risk of
injury from sharp edges.
→ Wear work gloves.
The chapter below describes the maintenance and repair of the
paint spray gun. Maintenance and repair work may only be carried
out by trained experts.
■ Stop the flow of compressed air to the compressed air connection
[1-9]
prior to performing any maintenance or repair work.
Replacement parts are available for repair work (see Chap. 15).
9.1. Replacing the trigger
Removing the trigger
■ Loosen the counter nut of the adjustment screw [1-4] .
■ Unscrew adjustment screw with counter nut and remove from gun body.
■ Remove spring and paint needle.
■ Carefully remove circlips.
■ Pull out both pins.
■ Remove trigger.
Attaching the trigger
■ Insert trigger.
■ Insert bracket pins.
■ Insert circlips.
■ Insert paint needle and spring.
■ Screw adjustment screw [1-4] with counter nut into gun body.