SATA 51085C, Инструкция по эксплуатации, Страница: 17 / 20

17 V_SC_51085C_202107
6. Installation or removal of bit (see Figure
E)
Caution: When installing or removing the bit, be
sure to confirm that the drill has been turned off
and that the battery pack has been removed.
The machine is designed with a quick-loading
chuck system;
When installing the screwdriver bit, pull the
sleeve forward and insert the screwdriver bit
into the chuck. Loosen the sleeve to fix the
screwdriver bit.
When removing the screwdriver bit, pull the
sleeve forward and pull the bit out, and then
release the sleeve to reset it.
WARNING
Before starting the machine, make sure that the
screwdriver bit is fully fixed by the chuck.
7. Work light
Machine is equipped with the work light: when
the switch is pressed, the light will come on;
when it is released, the light will go out 15s later.
8. Battery level indication
When the machine switch is pressed, the battery
indicator will stay on for 5s. The remaining
capacity of battery pack may be determined
according to the following table.
0-25%
25-50%
50-75%
75-100%
LED display Remaining battery
9. Operation
The proper tightening torque may vary
depending on the type or size of screw/bolt and
the material of workpiece to be fastened.
Hold the tool and place the tip of bit on the head
of screw. Apply a forward pressure to the tool to
rotating speed. The smaller the force is, the
lower the rotating speed is. The drilling starts
slowly and stably. After the stable and reliable
start, press the switch fully for higher speed.
3. Speed position selection (see Figure C)
First select the position, and then regulate the
rotating speed by operating the switch; the
highest position is selected at delivery and there
are three red position indicators (6) where three
ones coming on means the high position, two
ones coming on means the mid position and
one coming on means low position: Change the
position once each time you press the mark.
WARNING
Do not operate at low speed for a long time by
pressing the switch. Otherwise the machine
will be overheating inside. Change the rotating
speed after stop.
4. Switch lock (see Figure D)
The switch has the lock protection function
which helps to avoid the accidental activation of
the hand drill. Lock the machine by adjusting the
reversing yoke (2) to the center position.
5. Rotation reversing (see Figure D)
Forward: Push the side of reversing yoke (2)
marked with “
" to the end (left side) for
drilling a hole and driving the screw. Reverse:
Push the side of reversing yoke marked with “
" to the end (right side) for releasing or
unscrewing the screw the screw.
The rotating speed can only be changed after
the machine is completely still.
WARNING
The rotating speed can only be changed after
the machine is completely still.