5. Troubleshooting
6. Specification & Dimension
Model No.
PA-4510P (PET Type)
Detection
Passive Infrared motion detecting
Detection Range
Stereoscopic alert / alert distance : 10m / 84˚
Zone
Composition
37 Pairs (74 Zone)
Voltage
DC 8 ~ 18V (Polarity)
Current
20mA (MAX)
Alarm Output
Non-voltage contact (N.C / N.O)
Contact Volume: AC/DC 30V 0.2A Max
Protection Resistance : 18Ω
Alarm LED (RED)
LED On when warming up / LED off when setting /
LED on when detecting
Tamper Output
Non-voltage contact output (N.C)
Contact Volume: AC/DC 30V 0.2A Max
Temperature
-20
℃
~ 60
℃
Installation Site
Indoor
PET Function
Under 10kg
Material
COVER, BASE: ABS Resin, LENS: PE Resin
Dimension
102 x 64 x 47mm
Weight
68g
Installation Height
(2.5m)
Detection Distance (m)
3m
5m
7m
10m
Angle
20°
10°
5°
0°
※
Respective angels and detection distance when using optional bracket (B-4001)
<Sensitivity Adjustment>
▶ H (High Sensitivity) : For more sensitive detection
▶ L (Low Sensitivity) : For less sensitive detection
※Notice : This sensor is for indoor use only. Please do not install it in outdoor
- Sensitivity Adjustment
Problem0
Cause
Solution
When LED is not turned on,
Lines of electricity source are cut.
Check the lines
Electricity source is not correct.
Check it to DC 8 ~ 18V
No contact point although it is set
Cutting lines or abnormality of inner circuit
Check the lines of connection
No contact point when detected
Cutting lines or abnormality of inner circuit
Check the lines of connection
LED is not working when detected
Cutting lines, LED broken down or
abnormality of inner circuit.
Check the lines of connection
When there is abnormal working
There is dirt on the cover
Remove dirt with soft cloth
When it is exposed to direct ray of light
Install it to another place or block the light
When it can’t detect normally
Adjust the scope of alert
HI
LOW
