Sase Bull 300 EBS, Руководство пользователя, Страница: 14 / 22

3
Removing Elongated Bags
Access the filters by removing the vacuum producer section. To change
the
elongated
bags, clip the plastic wrap on each bag tied on the filter
shaker assembly inside the tank at the top.
Squeeze the spring cuff at the bottom of the bag compressing the snap ring into
a “U” shape, and remove from the bag plate hole.
Installing New Elongated Bags
Grasp the spring cuff at the bottom of the bag and compress into a “U” shape.
Insert into the proper hole in the bag plate, and release the bag bottom, assuring
the “groove” in the bag cuff is centered in the bag plate hole . The Bag cuff
snaps in to the filter hole and the “ snap ” can be heard by a low audible pop
sound. Ensure the bags are seated from underside of the filter plate by patting
inside of the cuff using a rubber mallet around filter plate. This will ensure the
seating of filter bag cuff evenly around the filter plate hole.
Use 5/16-18 hex nut to fasten the filters onto the filter shaker assembly.
After installing all the filters, check the installation from below; all the
filters should be neatly and evenly seated.
WARNING: Failure to assure proper seating of the bag in
the bag plate will allow material leakage.
Elongated Bag Specification
The
elongated
bags supplied with this system are:
Material: 12 oz. PTFE polyester felt with snap band
Quantity: 12
Length: 23.5”
Bag Plate Hole Size 4”
When re-ordering replacement
elongated bags
use Part Number from
enclosed parts list
Operators must be
outfitted with
appropriate
respirators and
must wear
protective clothing
if handling dust
that may be
irritating or toxic.
The most common
installation
mistake is to
release the cuff
lower than it
should be. The
groove in the bag
cuff matches the
hole size exactly.
Elongated Bag Re-order
Instructions