SAS HHO Phoenix 400, Руководство пользователя

Страница: 11 / 21

HHO-Canada Inc. User guide PH400 10
First time use
Before using the excavator for the first time, a full visual control must be done to check any damages that may have
occurred during transport or assembly. All the attachments must also be checked as well as the tracks’ tension and the
liquids levels (oils and fuel) and the excavator should be fully greased (see p17 for the grease points and p20 for the
maintenance schedule).
Excavator’s running-in period
Each new equipments have been tested before leaving the factory but still need a running-in period of 45 to 50h. During
the first 50 hours of use, is is imperative not to work full loads with the excavator and to follow theses rules :
-
Only warm up the excavator at medium engine speed with slow movements; do not warm up at low engine
speed
-
Do not submit the excavator to unecessary strong stresses.
Particular maintenance instructions
-
Change the motor oil after the first 5 hours of use,
-
Check the hydraulic oil for any visible impurity.
Starting up
To stat up the excavator :
-
Turn the comutator on the position ON (1)
-
Check if the fuel line is open (4)
-
Open the choke (3)
Once these conditions are met, pull on the cord (2) to start the motor, wait 10 seconds then close the choke.
To turn off the motor, turn the comutator (1) to the position OFF.
The procedure shown here is for the 6,5 hp motor and is the same for all motors. The 9,5 hp and 14 hp motors use an
ignition key as a comutator and can be started by either pulling the cord (2) or turning the ignition key.
4 3 5
1 2