2
Copyright © 2011, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A8130C
• Slide lock into the door
• Secure lock in door with (2) wood screws
#12 x 1-1/4" or machine screws #12-24 x 1/2"
• Do not tighten screws fully at this point
1
INSTALLATION Of LOCK
2
• The trim can be mounted vertically or horizontally
3
DETERMINE ORIENTATION AND HANDING Of TRIM
Tighten Cylinder
Clamping Screw
Outside of door
Page 2B
Note that the lock front
screws are not fully
tightened, screws will
be tightened once trim
is installed
Install Cylinder
* for non-cylinder functions proceed to STEP 3
• Thread the cylinder into the lockbody
• Verify the cylinder is flush with the collar and the
name is horizontal
• Secure cylinder with cylinder clamping screw
located above the deadbolt opening
• Verify the cylinder functions correctly
THRU
BOLT
THRU
BOLT
CHASSIS
SPRING
Vertical Mounting
Horizontal Mounting
THRU
BOLT
CHASSIS
CHASSIS
THRU
BOLT
THRU
BOLT
THRU
BOLT
SPRING
SPRING
THRU
BOLT
THRU
BOLT
CHASSIS
SPRING
To change from PUSH to PULL orientation, chassis will need
to be turned 180° and paddle installed in the correct direction
*NOTE: Chassis is packed with paddle attached
Remove paddle before installing
*NOTE: Before installing chassis to door, make sure
spring orientation is correct
INSTALLATION Of CyLINDER
