Sarasota Quality Products •
27330 Center Ridge Road •Westlake • Ohio 44145
Ph: (440) 899-9820
●
Fx: (440) 899-0930
●
www.sarasotaqp.com
3
CONFIGURING THE SYSTEM OR REPLACING A TRANSMITTER.
Remote Float™ Transmitters are configured to the Key Captain control
unit at time of assembly or whenever a new transmitter is purchased.
Each control unit will need to be configured (learn) about all the
transmitters before the system will function.
1.
To configure the system apply power the control panel (see
wiring instructions).
2.
Press the plunger of the learn switch located on the control
panel. This will place the control panel in the learn mode and
will disable the lock/unlock features from operating.
3.
With the control panel in the learn mode, press the lock button
on the transmitter for one second and release.
4.
Wait one second then press the lock button again, but hold
and do not release.
5.
The lock/unlock system will continue to be inoperable and will
not respond to the transmitter for another 10 seconds.
6.
Once the control panel has learned about the transmitter it will
respond to the transmitter and actuate the lock/unlock system.
7.
The control panel has learned about the transmitter and can
be used.
8.
Repeat steps 1-8 to configure additional transmitters.
KEY CAPTAIN™ SLEEP MODE
The Float Remote™ will put itself into a power saving “sleep mode”
when inactive for several minutes. It will reactivate when any
pushbutton is pressed.
KEY CAPTAIN™ AUDIBLE MODE
Each time a Float Remote™ pushbutton is pressed the control
panel will produce an audible “chirp’ to acknowledge to the operator
that the transmitted signal has been received. The audible may be
permanently disabled by clipping the jumper wire on outside of
control panel case.
To permanently disable audible signal,
cut jumper wire.
