The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
215.322.6063 P.
215.322.8498 F.
www.sapling-inc.com
14
Square Double Mount Installation
y
Snap and screw base to metal mounting bracket -
Snap the base to the metal mounting bracket by first making contact
with the lip in the upper side of the base and the metal mounting bracket. When the base has been snapped onto the bracket, take
the two (2) 6-32 x 1/2” pan head screws that originally came installed on the base and screw them back into the two holes on the
underside of the base to secure the base to the metal mounting bracket.
u
Connect switch box wires to clock harness -
Take the wiring harness supplied with the clock and make all necessary
connections between the wiring harness and the switch box wires using wire nuts. Perform this task for both clocks. If using IP
clocks, wiring will not be supplied with the clocks - the installer will be responsible for supplying all Ethernet wiring.
i
Plug and secure wiring -
Loosen and slip excess wiring through provided wire clamps (comes attached to each housing) and
tabs secure it to the back case. The user will choose the clamps and tabs used based on the amount of excess wiring present inside
the back case. Take the front of the clock that was separated from the back case in step 1 and plug the end of the wiring into the
appropriate jack on the movement.
o
Attach the front of the clock to the back case -
With the wiring now secured and properly plugged into the movement,
take the front of the clock and snap it back together with the back case.
Note: make sure the clock is facing in the upright
position
. Press the front of the clock into the back case, making sure the tabs that were disengaged in step one are properly
snapped back together.
Note: when pressing the front of the clock onto the back case, DO NOT press on the center of
the clock. Rather, push on the outer edges of the frame of the clock as to not damage the contents of the clock.
