_
English
_
INSTALLATION
WALL MOUNTED
Product installation steps:
1.
When mounted, enough space must be left around heater.
2.
Get three holes on the wall above the floor (see setting sketch A, B, C position), be sure to make
the diameter just the same as the expanding pipe. Insert plastic expanded pin into all three holes.
3.
Fix two screws on the expanding pipe (as sketch A & B position), keep the tips of the screws out
about 10mm, and hang up the machine after the screws are strong enough.
4.
Fix the bottom screw on the expanding pipe (as sketch C position).
Important: The screws must be fixed very strong in order to avoid machine falling.
OPERATION
Insert the plug into a wall socket. The following functions will occur when pulling to cord:
Pull the cord once:
-
One power indicator lamp light up and the appliance will power to 1000 watts.
Pull the cord twice:
-
Both power indicator lamps light up and the appliance will power to 2000 watts.
Pull the cord third time:
-
This will turn the heater OFF.
The heater is fitted with a
safety device
which will switch off the heater in case of
accidental
