18
BEFORE OPERATION
Operating Range
Point Remote Control Unit toward
projector (Receiver Window)
whenever pressing any button.
Maximum operating range for
Remote Control Unit is about 16.4’
(5m) and 60° in front and rear of a
projector.
16.4’
(5 m)
60°
16.4’
(5 m)
60°
To insure safe operation, please observe following precautions :
●
Use (2) AA, UM3 or R06 type alkaline batteries.
●
Replace two batteries at same time.
●
Do not use a new battery with an used battery.
●
Avoid contact with water or liquid.
●
Do not expose Remote Control Unit to moisture, or heat.
●
Do not drop Remote Control Unit.
●
If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
●
Danger of explosion if battery is incorrectly replaced.
●
Dispose of used batteries according to batteries manufacturers instructions and local rules.
Press lid down-
ward and slide it.
Remove battery
compartment lid.
Slide batteries into
compartment.
Replace compartment lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
Remote Control Batteries Installation
1
2
3
Used to operate P-
TIMER function. (P23)
LOCK
FREEZE
SELECT
D.ZOOM
MUTE
VOLUME-
MENU
NO SHOW
IMAGE
KEYSTONE
LASER
P-TIMER
ZOOM
INPUT 1
INPUT 2
FOCUS LENS
AUTO PC ON-OFF
INPUT 3
NETWORK
P-TIMER BUTTON
Used to adjust zoom. (P22)
ZOOM BUTTON
NO SHOW BUTTON
Used to turn picture into
black image. (P23)
D.ZOOM BUTTON
Used to select DIGITAL
ZOOM +/– mode and
resize image. (P33)
FREEZE BUTTON
Used to freeze picture. (P23)
MENU BUTTON
Used to select MENU
operation. (P18, 19)
INPUT 1 BUTTON
Used to select input
source (INPUT 1).
(P25)
SELECT BUTTON
Used to execute the
selected item, or to
expand or compress
image in DIGITAL ZOOM
+/- mode. (P33)
POINT (/-)
BUTTONS
Used to select an item or
adjust value in ON-SCREEN
MENU. They are also used
to pan image in DIGITAL
ZOOM +/- mode. (P33)
POINT LEFT/RIGHT buttons
are also used as VOLUME
+/- buttons. (P24)
INPUT 2 BUTTON
Used to select input
source (INPUT 2).
(P25, 34)
INPUT 3 BUTTON
Used to select input
source (INPUT 3).
(P34)
NETWORK BUTTON
This button will be used
when a network function
(interface board :option) is
added in the future.
