Sanyo VPC-X1400BL, Руководство по обслуживанию

Страница: 15 / 48

– 15 –
3-8. Adjust Specifications
1. Lens Adjustment (1m)
Preparation:
POWER switch: ON
Adjustment condition:
Siemens star chart (A3)
Fluorescent light illumination with no flicker
Illumination above the subject should be 700 lux
±
10%.
Note:
Do not vibrate during the adjustment.
The temperature of the camera should be allowed to reach
room temperature before adjusting the focus. If any slight in-
creases or decreases in room temperature occur, wait until
the temperature of the camera reaches room temperature
before carrying out adjustment.
Adjustment method:
1. Set the siemens star chart 100
±
0.5 cm from lens surface
(zoom wide position) so that it becomes center of the screen
(zoom wide and tele).
2. Double-click on the DscCalDi.exe.
3. Click the “Focus”, and Click the “Yes”.
4. Lens adjustment value will appear on the screen.
5. Click the OK.
3-6. The adjustment item which in necessary in part exchange
COMPL PWB CP1
Factory
Cord
Setting
Language
Setting
COMPL PWB ST1
COMPL PWB ST2
ASSY, FLEXIBLE PWB CA1
Reset
Setting
AWB
Adjust-
ment
USB
storage
information
registration
CCD White
Point
Defect
Detect
Adjustment
CCD Black
Point And
White Point
Defect Detect
Adjustment
In Lighted
: Be sure to carry out the necessary adjustments after replacing the unit.
: Adjustment is possible from the menu setting screen of the camera and by using the calibration software.
Lens
Adjust-
ment
(Infinity)
3-7. Updating the firmware
Check the firmware version immediately after the CP1 board has been replaced. If an old version is being used, interfer-
ence and errors in operation may also occur. If an old version is being used, update it with a newer version.
Refer to
3-13. Firmware uploading procedure. (Page 19)
LENS
Lens
Adjust-
ment
(1m)
Camera
100 0.5 cm
Siemens
star chart