Sanyo VPC-CG9 - Xacti Camcorder - 9.1 MP, Руководство по обслуживанию

Страница: 18 / 34

– 18 –
3-8. Adjust Specifications
1. Lens Adjustment (Infinity)
Preparation:
POWER switch: ON
If using a ready-made collimator, set to infinity.
Note:
Do not vibrate during the adjustment.
The temperature of the camera should be allowed to reach
room temperature before adjusting the focus. If any slight in-
creases or decreases in room temperature occur, wait until
the temperature of the camera reaches room temperature
before carrying out adjustment.
Adjustment method:
1. Set the camera so that it becomes center of the siemens
star chart in the collimator (zoom wide and tele).
(Set a distance of 0.5-1.0 cm between camera lens and
collimator lens when zoom tele edge. Do not touch the
each lens.)
2. Double-click on the DscCalDi.exe.
3. Select “Infinity Cal.” on the LCD “Test”, and click the “Yes”.
4. Lens infinity adjustment value will appear on the screen.
5. Click the OK.
2. Lens Adjustment (1m) is carried out after this adjust-
ment.
3-6. The adjustment item which in necessary in part exchange
Camera
Collimator
COMPL PWB CP-1
Factory
Cord
Setting
Language
Setting
COMPL PWB VF-1
COMPL PWB ST-1
COMPL PWB TB-1
Reset
Setting
LENS
Lens
Adjust-
ment
(1 m)
AWB
Adjust-
ment
USB
storage
information
registration
CCD White
Point
Defect
Detect
Adjustment
CCD Black
Point And
White Point
Defect Detect
Adjustment
In Lighted
: Be sure to carry out the necessary adjustments after replacing the unit.
: Adjustment is possible from the menu setting screen of the camera and by using the calibration software.
Lens
Adjust-
ment
(Infinity)
ASSY, FLEXIBLE PWB COMP3
Dsc Calibration
x
OK
Infinity calibration :
AF_TEMP_AD_I: 329
PZ_BR: 8
AF_BR: 6
AF_I_WIDE: -16
AF_I_MID1: -18
AF_I_MID2: 2
AF_I_TELE: 49
IRIS_GAIN: 62
IRIS_OFFSET: 107
Copy
3-7. Updating the firmware
Check the firmware version immediately after the CP1 board has been replaced. If an old version is being used, interfer-
ence and errors in operation may also occur. If an old version is being used, update it with a newer version.
Refer to
3-13. Firmware uploading procedure. (Page 21)