PARTS NAMES
1
AC input socket (AC INPUT)
Connect the AC power cord (supplied) securely to this socket
and to a wall outlet.
2
Video input terminals (VIDEO IN)
These terminals are used to input a video signal source to
this monitor.
Connect to the video output of a VCR or another monitor (for
loop through connection) or to a video camera.
3
Video output terminals (VIDEO OUT)
These terminals are used to output a video signal from this
monitor.
Loop-through output of the video in BNC connector, then
connect to the video input of another monitor or a VCR.
4
Termination Switch (HI/75
Ω
(Lo))
Select the input impedance (HI/75
Ω
).
When using only one monitor, turn the termination switch to
the 75
Ω
position. When using more than one monitor, set all
of the termination switch on the monitors to the HI position.
However, the last monitor termination switch should be in the
75
Ω
position for proper line termination.
5
Sub-brightness control (SUB-BRI)
Turn to adjust picture brightness.
6
Vertical Size control (V-SIZE)
Turn to adjust picture vertical size of the picture.
7
Vertical hold control (V-HOLD)
If the picture is scrolling up or down on the screen, turn this
control until there is a single steady picture.
CONNECTION
Before connecting your system, make sure that all units are turned off.
The picture signal source can be connected to either the A or B terminal at the rear of the monitor. The monitor selector switch at the
front of the monitor can be used to select the input terminal used.
Single Connection
Note: The components and connection cables are not included and must be purchased separately.
Monitor
Video recorder
Video camera
To Video B
INPUT terminal
(Video signal cable)
To Video A
INPUT terminal
(Video signal cable)
(Rear panel)
To Video input
terminal
To Video input
terminal
Monitor
Video recorder
L8MAA/XE, UK, AU (VMC-6609P, 6612P, 6615P, 6620P GB) 2000. 11. 21
4
