Sanyo VCC-WB2000, Инструкция по эксплуатации

Страница: 20 / 52

Network Camera Settings
1
Changing a password
Example: To change the password for the
Administrator level (ID3) to “ 1234”
Passwords can consist of between 4 and 8
numerals.
☞
Type “1234” as the password in the
password column for ID3, and then click the
[SET] button.
A pop-up menu will be displayed. Click the [OK]
button. The following screen will then be
displayed. Check that the details are correct,
and then close the window.
(When a password has been changed)
When the camera and the computer are
connected once more, the network password
entry window will be displayed, so check the
username and type in the new password
(“1234”) into the Password box.
2
NETWORK SPEED
This sets the speed of data transmission by
the camera.
Available settings:
NO LIMIT: No limit on data transmission speed
64, 128, 256, 512, 1024 (Kbps)
3
HTTP PORT NUMBER
When more than one camera is connected to a
broadband router and a single IP address for
that router is being used to make the images
being monitored by the camera publicly
available over the Internet, this setting is used to
set the router’s port number to use. Refer to the
documentation provided with the broadband
router for further details.
Normally the HTTP PORT NUMBER setting
should be left at the default value of “80” without
being changed, even if more than one camera is
connected to the network.
4
MAC ADDRESS display
This shows the Mac address for the camera.
Note:
•
Up to a maximum of 16 individual users can
access a single camera on the network at
the same time. However, only one user out
of this maximum of 16 users can be
accessing at Operator or Administrator level
at any one time.
•
Depending on the network environment, it
may not be possible for 16 users to be
connected to a camera at the same time.
Once a user has accessed a camera, the
network may not allow further accesses, so if
this happens, reduce the resolution or
increase the compression ratio for the
transferred data to reduce the volume of data
being transferred.
•
If a 17th user tries to access a camera, the
message “THE UNIT IS BUSY!” will be
displayed on their screen. Depending on the
network environment, the message “THE
UNIT IS BUSY!” may be displayed on a
user’s computer screen even when less than
16 users are accessing a camera.
•
If a user at Administrator level accesses a
camera while a user at Operator level is
accessing the camera, the Administrator
level user will have priority. In such cases,
the Operator level user will be disconnected
and the message “THE UNIT IS
DISCONNECTED!” will be displayed on their
screen.
•
Depending on the network environment, the
speed of data transmission to users may
drop if the number of users accessing the
same camera increases, and operations
such as refreshing of images may become
delayed.
L5AB2/US (VCC-WB2000) GB 2002, 7, 4
English
– 19 –