SETTINGS
White balance adjustment
Normally the switch
8
(
WB
) is set to the down (
ATW
: auto white
balance) position and the white balance is adjusted automatically. If a
manual white balance adjustment is necessary, follow the steps below.
Set the switch
8
(
WB
) to the up (
M
: manual) position, then adjust the
colour.
•
Turn
RED
(VR302) to set the red ratio and/or
BLUE
(VR303) to set
the blue ratio.
Synchronization settings
The default setting is internal synchronization (
INT
). You can
change the power supply synchronization by moving switch
9
to the up (
LL
) position. Refer to “
Line phase adjustment
”
for details.
External sync adjustment (VBS) (VCC-6592P only)
1
Connect the VBS signal output for the other camera to the
VBS
IN
connector at the rear of this camera.
2
If the signals are not synchronized, change the sub-carrier (SC-P1)
switches as follows.
Setting
9-pin
10-pin
Default
OFF (down)
OFF
Set to 90˚ counterclockwise
OFF
ON (up)
Set to 180˚ counterclockwise
ON
OFF
Set to 270˚ counterclockwise
ON
ON
Note:
•
The sub-carrier switches let you make broad adjustments to the
sub-carrier phase. If finer adjustments are required, contact the
place of purchase.
•
The type and length of the cable which is connected to the VBS
connector may cause the horizontal synchronization being out of
phase. If this happens, adjust
VR304
(
H-P
: horizontal sync).
8
VR303
B
R
VR302
10
9
VR304
H-P
L53H2, H4/XE GB 2001, 9, 18
16
English
