2
Make sure to also consult the relevant instruction manuals.
1
Mark the locations on the wall and drill the
holes for the cables and screws.
And pull out the cables from the wall hole and
pass them through the bracket as shown in
the figure.
2
Fix the bracket to the wall using commercially
available screws (A) in 4 places.
3
Mount the dome cover and the power board
unit onto the housing.
☞
For details, please refer to the Outdoor Housing
Instruction Manual.
“
1. Attaching the dome cover
”
“
2. Mounting the power board unit
”
4
Attach the supplied rubber bands (B) to the
housing as shown in the figure.
5
With sticker (C) facing toward you,
temporarily mount the housing on the
bracket.
6
Fix the housing onto the bracket using 4 sets
of supplied bolts and bolt washers (D).
• To fix the housing, use the hexagonal wrench
supplied with the housing.
• Make sure that the housing is fixed, peel off the
sticker, then remove the rubber band.
7
Connect the cables to the power board unit
and mount the camera unit onto it.
☞
For details, please refer to the Outdoor Housing
Instruction Manual.
“
3. Connecting cables
”
“
4. Mounting the camera unit
”
• Be sure to fix the bracket securely using M8 (5/16”)
screws. Using other bolt sizes may cause the
bracket to fall together with the camera on it.
• Route the connected cables so that they do not
touch the power board unit and other parts.
Outdoor Type
This mounting bracket can be installed on a pole or a wall
corner by using the appropriate mounting adaptor. For
installation details, refer to the instruction manual for the pole
mounting adaptor (VA-80AP) or the corner mounting adaptor
(VA-80AC).
3
3
D
D
C
A
A
B
M8 (5/16”):
40 mm (1.6”) or more
Video cable
Connection cables
Outdoor Housing: VA-80EX
Dome Cover:
• VA-CM8C (Clear)
• VA-CM8S (Smoked)
Video cable
Power Board Unit:
VA-84S/80S
1. Attaching the dome cover
2. Mounting the power board unit
L9BHM_WA(VA-80BW)(GB_JP).book 2 ページ ２００６年１２月２７日 水曜日 午前１１時１９分
