05_SAP-KRV93EHFP_IT.fm Page 107 Tuesday, November 22, 2005 3:35 PM
For Evaluation Only.
Copyright (c) by Foxit Software Company, 2004
Edited by Foxit PDF Editor
For Evaluation Only.
Copyright (c) by Foxit Software Company, 2004
Edited by Foxit PDF Editor
A. Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
B. Setting the airflow manually
Referring to the above illustration, use the
FLAP button to set the airflow direction
within the range used during the heating,
cooling, or dehumidifying operation.
NOTE
•
The flap automatically closes when the unit is off.
•
During the heating operation, the fan speed will be very low and the
flap will be in the horizontal position (position
6
) until the air being
blown out of the unit begins to warm. Once the air warms up, the flap
position and fan speed change to the settings specified with the
remote control.
CAUTION
VERTICAL (manual) FRV
Hold the end of the flap and move it up and down to adjust the vertical air flow.
VERTICAL VANE
for heating and deumidifyng
for cooling
HOW TO ADJUST THE FLAP DIRECTION
•
Use the FLAP button on the remote control to adjust the position of
the flap. If you move the flap by hand, the factual flap position and the
flap position on the remote control may no longer match. If this
should happen, shut off the unit, wait for the flap to close, and then
turn on the unit again; the flap position will now be normal again.
•
Do not have the flap pointed down during cooling and drying
operation. Condensation may begin to form around the air vent and
drip down.
VERTICAL (with remote control unit) FTRV
Make sure that the remote control unit has been turned on.
Press the FLAP button to select the sweep function or to choose
one of the six positions of the flap.
HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the vertical
vanes to the left or right, as indicated in the following figures for
each model.
Set vertical vanes to the front position during COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most position, condensation will form around the air outlet
and drip off.
CAUTION
VERTICAL VANE
VERTICAL VANE
FLAP
60°
40°
OFF
60°
40°
OFF
HOW TO ADJUST THE FLAP DIRECTION
6
4
5
3
2
1
COOL and DRY
HEAT
SWEEP
SWEEP
MODELS FRV-FTRV
2
4
