Electrical component
box cover
Panel motor
P.C.Board
Electrical component
box cover
P.C.Board
Remove this tab
first, and then
remove other tabs
while slightly raising
the P.C.Board.
Tab
Cap (resin)
Screw
Panel motor
To the
P.C.Board
Electrical
component
box cover
(4-3) Disconnect all the connectors on the
P.C.Board.
(4-4) Replace the P.C.Board.
8-4. Removing the Panel Motor
Remove the electrical component box cover
according to the previous section.
And carry out the procedure up to the "step
(4-2) in 8-3. Removing the electrical
component box."
(1) Disconnect and remove the connector for the
lead wire of the panel motor at the P.C.Board
side.
(2) Remove the screw on the panel motor and
cap (resin).
When mounting a new panel motor, make sure that
the gear of the panel motor and that of the electrical
component box cover firmly engage with each other.
(4-5) Pulling out the lead wire after replacing the
P.C.Board.
NOTE
32
