Operation with the Remote Control Unit (continued)
NOTE
•
This appliance has a built-in 3-minute time delay circuit to ensure
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the
unit will restart automatically after three minutes.
3. Adjusting the
Fan Speed
A. Automatic
Simply set the FAN SPEED selector button to the
position.
A microcomputer in the air conditioner automatically controls the fan
speed when the
mode is selected. When the air conditioner starts
operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automatically
switches the fan speed to the most suitable level.
NOTE
•
When the microcomputer in the air conditioner selects High Fan
Speed during automatic operation, the fan starts to rotate at HH
(Very High) for 5 minutes.
•
When heating operation is selected, HH Fan rotation starts after the
Cold Draft Prevention System has finished operation.
•
The fan speed after HH Fan rotation finishes is determined by the
difference between the room temperature and the set temperature
as shown in the charts below.
•
Manual setting is recommended if the HH Fan Speed is
uncomfortable.
Cooling and DRY mode:
When difference between
room temperature and set
temperature is
FAN SPEED
2°C and over
High
Between 2°C and 1°C
Medium
Below 1°C
Low
Heating mode:
When difference between
room temperature and set
temperature is
FAN SPEED
2°C and over
High
Below 2°C
Medium
NOTE
The above table assumes that the sensor on the remote control is being
used. If the sensor on the indoor unit is being used (the
indicator is
on), actual operation may differ slightly from the operation described in
the table.
(Refer to ‘‘SENSOR button’’ on page 9.)
B. Manual
If you want to adjust fan speed manually during operation, just set the
FAN SPEED selector button as desired. [
,
, or
]
14
OI-400-14EG
oi400000
