Sanyo PLV-Z1, Руководство по обслуживанию

Страница: 4 / 67

-4-
■
Lamp Replacemant
■
Lamp Replacement
When the life of the projection lamp draws to an end, the LAMP
REPLACE indicator lights yellow. When this indicator lights yellow,
replace the projection lamp with a new one promptly.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the
following information to the dealer.
●
Model No. of your projector : PLV-Z1 / PLV-Z1BL
●
Replacement Lamp Type No. : POA-LMP54
(Service Parts No. 610 302 5933)
FOR CONTINUED SAFETY, REPLACE WITH A LAMP
ASSEMBLY OF THE SAME TYPE.
DO NOT DROP A LAMP ASSEMBLY OR TOUCH A
GLASS BULB! THE GLASS CAN SHATTER AND MAY
CAUSE INJURY.
ALLOW A PROJECTOR TO COOL, FOR AT LEAST 45
MINUTES BEFORE YOU OPEN LAMP COVER. THE
INSIDE OF A PROJECTOR CAN BECOME VERY
HOT.
WARNING ARNING
TEMP TEMP.
LAMP
REPLA REPLACE CE
RE READY
LAMP
MENU INPUT
ON-OFF ON-OFF
SELECT
CAUTION
Follow these steps to replace the lamp assembly.
LAMP
ASSEMBLY
HANDLE
LAMP COVER
This indicator lights yellow
when the life of the projection
lamp draws to an end.
Replace the Projection Lamp
with a new one.
SCREW
SCREW
SCREW
TOP CONTROL
1.
Turn off the projector and disconnect AC plug. Allow the projector
to be cooled for at least 45 minutes.
2.
To remove the Lamp cover, remove the screw with a screwdriver.
3.
Remove 2 screws with a screwdriver and pull out the Lamp assem-
bly by grasping the handle.
4.
Replace the Lamp assembly with a new one and tighten 2 screws
back into position. Make sure that the Lamp assembly is set prop-
erly. Replace the Lamp cover and tighten the screw.
5.
Connect the AC Power Cord to the projector and turn on the projec-
tor.
6.
Reset the Lamp Replace Counter.
Refer to “Lamp Replace Counter” on the next page .
NOTE : Do not reset the Lamp Replace Counter when the
Projection lamp is not replaced.