Sanyo PLC-XU84, Руководство пользователя

Страница: 50 / 73

50
Setting
Power management
Time left before Lamp is off.
Power management
For reducing power consumption as well as maintaining the
lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with “No signal”
appears. It starts the countdown until the lamp is turned off.
Use the Point
7 8 buttons to set the countdown timer.
Select one of the following options:
Ready ................... When the lamp has been fully cooled
down, the POWER indicator changes to
green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the top control or remote control is
pressed.
Shut down............ When the lamp has been fully cooled
down, the power will be turned off.
Off ........................ Power management function is off.
Standby mode
This function is available when operating the projector via
network.
Normal ....... Supply the power to the network function
even after turning off the projector. You can
turn on/off the projector via network, modify
network environment, and receive an e-mail
about projector status while the projector is
powered off.
Eco ............. Select “Eco” when you do not use the
projector via network. The projector’s network
function will stop when turning off the
projector.
Refer to the owner’s manual “Network Set-up and
Operation”.
✔
Note:
•When selecting Normal, the cooling fans may be running
depending on the temperature inside the projector even if the
projector is turned off.
Press the SELECT button at
Power management and this
dialog box appears. Use the
Point
7 8 buttons to choose
one of the three options.
Press the Point
d button to
select the timer, and then
use the Point
7 8 buttons to
set timer.