Sanyo PLC-XD2200, Руководство пользователя

Страница: 51 / 78

51
Setting
Standby mode
This function is available when operating the projector via
network.
Network .... Supply the power to the network function even
after turning off the projector by pressing the
ON/STAND-BY button on the remote control.
You can turn on/off the projector via network,
modify network environment, and receive
an e-mail about projector status while the
projector is powered off.
Eco ............ Select Eco when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector, you
can not turn on the projector via network.
Refer to the owner’s manual of “Network Set-up and
Operation”.
✔
Note:
• When selecting Network , the cooling fans may be
running depending on the temperature inside the
projector even if the projector is turned off.
• When Eco mode is selected and the projector is in Stand-
by, the communication of RS-232C serial port is not
available.
Start
Reset
Exit
This function allows you to change the setting of the P-timer and
execute it.
Select one of the following options:
Count up ............. The P-timer display 000:00 appears on the
screen and the count starts ( 000:00–180:00 )
Count down ......... The time set in the Timer setting appears on
the screen and the countdown starts.
Timer .................... Use the Point ▲▼ buttons to set the Timer
( 1–180 Min ). Timer is available in Count
down only . Factory default velue is 10 Min .
Start ..................... It executes the count up or count down
function. Press the SELECT button at
Start and the indication changes into
Stop. To stop Count up or Count down ,
press the SELECT button at Stop on the
screen menu,then the indication changes
into
Restart . Press the SELECT button
at Restart to resume Count up or Count
down .
Reset ................... Reset the P-timer values.
Press the SELECT button at Reset to return
to the following value;
Count up ... "000:00"
Count down ... Timer that you set
Exit ....................... To exit the P-timer operation.
P-TIMER
P-timer display
0
Stop or Cancel the P-timer via Remote Control
To stop the P-timer, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
P-timer