LENS REPLACEMENT PROCEDURE
REMOVE THE LENS COVER. (See figure-1.)
1
1. Turn on the LCD projector.
2. Adjust the lens shift, so that lens is set in
the center.
3. Turn off the LCD projector and disconnect
the power cord from the AC outlet.
4. Remove 4 screws of the lens cover and
remove the lens cover.
REMOVE THE LENS. (See figure-2.)
2
1. Remove the connector
“K16B” of the circuit board.
2. Loosen the A, B wire bands,
wire holder and remove the
lens motor lead.
After removal of the lens
motor lead, fasten it by plac-
ing it back into position.
3. Remove screws D(4 screws)
which fastens the lens and
remove the lens.
LENS
MOTOR LEAD
CONNECTOR “ K16B “
(D)
(D)
(D)
(D)
B
A
C
LENS MOTOR
Fig-2
This part wiring should
not be tightened.
❋
Figure shown inside of the cabinet.
Fig-1
LENS COVER
1
5
Perform the steps
to
for lens replacement.
WIRE HOLDER
