Fig-6
Fig-7
Fig-8
3
REMOVE THE LENS (See Figure-5 and 6)
Remove the connector "K16J" of the circuit board.
Remove the lens motor lead from lead holder.
Remove screws-C (4 screws) which fastens the
lens and remove the lens. Use the driver (3 mm,
Green) included with the lens to remove the
screws.
1
.
2.
DRIVER
IN THE LENS
LENS MOUNTING
BRACKET
4
MOUNT THE LENS (See Figure-5 and 6)
5
MOUNT THE LIGHT-BLOCK SHEET BASE
(See Figure-7)
6
MOUNT THE LIGHT-BLOCK SHEET AND
LENS COVER (See Figure-8)
Be careful not to drop the lens when removing the
screws.
After using, save the driver for latter use.
Remove protective caps (front and back) on the
lens.
Mount the lens on lens mounting bracket with 4
screws. (locate motor on left side).
Use the driver (4 mm, Yellow) included with the
lens to fasten the screws.
1
.
2.
After using, save the driver for latter use.
Connect the lens motor lead to the connector
"K16J" of the circuit board.
Connect the lens motor lead to the lead holder.
3
.
4.
Mount the light-block sheet base to the projector.
Mount the light-block sheet to the light-block sheet
base as shown in the Figure-8. (In the same
position as the removed sheet has been placed).
Use the sheet included with the lens.
Make sure the part no. and mark (TOP and BACK)
on Light-Block Sheet and set them properly.
Mount the lens cover with the screws.
1
.
2.
3.
1
.
LENS COVER
LIGHT-BLOCK
SHEET
LIGHT-BLOCK
SHEET BASE
(Part No. 412 062 3705)
LENS
MOTOR
LEAD
HOLDER
CONNECTOR "K16J"
LENS MOTOR LEAD
SCREW "C"
Fig-5
-3-
