7
8
70cm(28
"
)
or more
70cm(28
"
)
or more
Back rest
Foot rest
1
Remove the screws (x2)
from the head rest.
3
Unzip the fastener of the back
pad, and cover the back rest
with the back pad.
4
Zip up the fastener of the back
pad.
2
After inserting the head rest
into the pipe, secure the head
rest firmly with
the screws (x2).
Before moving the chair, be sure to remove
the power plug from the outlet.
Be careful not to step on the power cord during
movement.
Be sure to move the chair with the assistance
of another person on an easily damaged floor
surface or concrete surface.
Before moving the chair, make sure that the
head rest is securely attached. (See page 8)
Be careful when moving the chair by holding
the head rest as doing so may cause the head
rest to tilt forward.
The chair can be carried by two persons with
each holding the arm rests on the left and the
right respectively. In this case, however, ensure
that the control is not raised.
NOTE
NOTE
Place the chair on a level floor surface.
Keep the chair at least 1 meter(3 ft) away from AV machines like a TV or radio.
Otherwise, the program may be disturbed by noise.
Do not keep the chair in a place with high humidity like a bathroom.
Do not keep the chair in a place where it will be exposed to direct sunshine for an extended
period, or in a place near a heater where the temperature may reach high levels.
In order not to touch the wall or other
things when reclined, allow a clearance
of 70 cm(28
"
)
or more to the front and
the back of the chair.
2
Ensure there is sufficient space
to allow the chair to recline.
Decide where to place it
How to move the chair
PUSH
PULL
PREPARATIONS PRIOR TO USE
HOW TO INSTALL THE HEAD REST AND PILLOW
3
How to connect the power source.
①
②
Insert the power plug into an outlet.
Set the POWER switch to the "ON"
position.
1
Check the cloth of the chair.
Prior to use, be sure to check that the cover
cloth or the cloth of other parts is not torn.
If a tear is found, stop using the chair
immediately, unplug the power source, and
obtain service. If the chair is used with
torn cloth, it may result in injury or electric
shock.
2
Check the power cord.
Check that there is neither breakage nor
damage to the cords.
Check that the cords are not caught between
the back rest and the arm rest, and that they
are not placed beneath the chair.
HOW TO PLACE THE CHAIR
Movement becomes easier when the back
rest is raised. (See page 10)
1
Raise the back rest.
2
Raise the front side of the chair,
and move it using the casters.
It prevents damaging the floor, and
muffles the noise during use.
1
Lay a carpet, etc. on the set-up
place.
Back rest
Back rest
Foot rest
Caster
To move the chair, one person should
hold the foot rest and the other should hold
the back rest with the back rest reclined.
Carpet
POWER switch
Press
＊
＊
Back pad
Head rest
Pipe
Back pad
Head rest
Back rest
Pillow
Head rest
Back pad
fastener
fastener
Head rest
Screws
Screws
Hole
Hook and loop
fasteners
5
Secure the head rest and the
back pad with the hook and loop
fasteners.
6
Place the pillow on the head
rest.