GB–5
GENERAL OPERATION
TURNING THE POWER ON ........................................ 1
Install the front panel and press the PWR MUTE button 1 when ACC is on.
TURNING THE POWER OFF ............................................................. 1
Press the PWR MUTE button for more than 2 seconds. Display will revert to clock indication.
When you turn on the unit, “ Hello ” will be displayed then “ Welcome ” will momentarily be displayed before
actual power on.
When you turn off the unit, “ See You ” will be displayed then “ Good-Bye ” will momentarily be displayed
before actual power off. You can edit these messages. (See page 12 “TURN ON/OFF MESSAGE EDIT”).
VOLUME LEVEL CONTROL....................................... 2
Rotate the VOLUME dial 2 to adjust the volume level.
MUTING THE SOUND .......................................................................... 1
Press the PWR MUTE button 1 while the receiver is on. To restore the previous volume level, press PWR
MUTE button again.
SETTING THE CLOCK ........................................3,1,2
The clock uses a 12-hour display system.
1.
Repeatedly press the MENU button 3 to display “ Clock adj. ” .
2.
Press the PWR MUTE button 1 to enter the clock adjustment mode.
3.
Press the following button/dial to set the clock.
PWR MUTE 1
: To switch hour/minute blink.
VOLUME dial 2
: Adjust the hour and minutes.
4.
Press the MENU button 3 to activate the clock. After few seconds, the unit returns to previous indication.
IGNITION-OFF CLOCK RECALL ........................................................ 3
Press the MENU button 3 while the ignition switch is in the “ OFF ” position.
The display will illuminate showing the time and then automatically shut off after 5 seconds.
SWITCHING THE SOURCE ................................... 4,5
You can connect the auxiliary equipment (Portable cassete player, etc) to this unit. Each time the CD
button 4 is pressed, the operation source will change over as shown below;
Press the BAND ATP button 5 to return to radio mode.
If the CD button 4 is pressed when no CD has been loaded into the unit, The CD mode will skip to the AUX
mode.
1
3
4
2
5
