WIRING
1. DIN cable
Connect this cable to the
LB,
LB/FM Modulator/Ground Isolator or Divider unit.
2.
Power wire (YELLOW)
Connect this wire to a terminal which is always energized.
When fuse replacement is necessary, use only a 5 amp fuse.
3. Ground wire (BLACK)
Attach this wire to the chassis of the car. Be sure that the surface is free of paint, and is not rusty. If a proper ground connection
is not made, the CD changer may not operate correctly and stray noise may be picked up by the unit.
4. Reset button
l
Be sure to press this button when all wiring is completed or when car battery is replaced.
l
Press the reset button when a malfunction occurs during CD play
appears in the display).
The magazine comes out.
* If the magazine dose not come out or
often appear in the display, please contact the place of purchase.
5. Changer selector switch
Do not use this switch if only CD changer is being used. It is used only when 2 CD changers (FXD-C222) are attached.
On how to use it, refer to the operation manual of the divider unit (FTP-CH1 S).
SPRING ATTACHMENT
This CD changer can be installed either horizontally or vertically. It is necessary to change the direction of the spring attachment
according to the installing direction.
Choose where to install the CD changer and decide whether to install it horizontally or vertically.
l
Horizontal Installation
1) The default setting is horizontal. Check that the spring attachment is on the (H) mark side as shown in the diagram.
Vertical Installation
I
I
It is necessary to change the spring attachment position.
1) Remove the lock screws on the side of the set using a Phillips screwdriver.
2) Turn the spring attachment to the (U) mark side using a screwdriver.
3) Reset the screws on the (V) mark side.
