Sanyo DMP-P3, Инструкция по эксплуатации

Страница: 5 / 14

PREPARATION FOR USE
Before Setting Up The Unit
• Operate controls and switches as described in the manual.
• Before turning on the power, make certain that the power cord is properly
installed.
• When moving the unit, be sure to first disconnect the AC power cord.
• Avoid installing this unit in places exposed to direct sunlight or close to heat
radiating appliances such as electric heaters, on top of other stereo equipment
that radiates too much heat, places lacking ventilation or dusty areas, places
subject to constant vibration and/or humid or moist areas.
Unpacking And Setting Up
• Remove the product from the carton and remove all packing material from the
unit. We suggest that you save the packing material, if possible, in the unlikely
event that your unit ever needs to be returned for service. The original carton
and packing material is the only safe way to pack your product to protect it from
damage in transit.
• Remove any descriptive labels or stickers on the front or top of the cabinet. Do
not remove any labels or stickers from the back or bottom of the cabinet.
• Place your unit on a level surface such as a table, desk or shelf, convenient to
an AC outlet, out of direct sunlight, and away from sources of excess heat, dirt,
dust, moisture, humidity, or vibration.
• Unwind the FM antenna and extend it to its full length. It must be fully extended
to provide the best FM reception.
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' at the bottom of the unit to
prevent the product from moving when you operate the controls. These 'feet' are
made from non-migrating rubber material specially formulated to avoid leaving
any marks or stains on your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to
soften, and leave marks or a rubber residue on the furniture. To prevent any damage
to your furniture we strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement centers everywhere, and
apply these pads to the bottom of the rubber 'feet' before you place the product on
fine wooden furniture.
-3-