E8
Installing the belt clip
▼
To attach the belt clip
Insert the belt clip into the holes
on each side of the handset. Press
down until it clicks.
Headset installation
Your phone may be used with an optional headset.
To use this feature, simply plug any standard shield-
ed headset with a 2.5-mm plug into the headset
jack.
▼
To remove the belt clip
Insert a standard flat head
screwdriver into a notch of the
belt clip, then remove the belt
clip as shown below.
If you have wall-mounted the base, you
must install the belt clip to hold the
handset in the proper charging position.
Do not hang the handset with the keypad
facing inside.
Installing the Belt clip
Suggestion
• Make sure the AC adaptor is plugged into the base and wall outlet.
• Make sure the handset is properly seated in the base.
• Make sure the rechargeable battery pack is properly connected in the handset.
• Make sure that the charging contacts on the handset and on the base are clean.
• Make sure that the base antenna is in the vertical position.
• Interference by other electronics equipment such as TVs, computers, microwaves,
fluorescent lighting, etc.
• You may have gone too far from the base.
• Press
SCAN
to search for clearer reception.
• Check both ends of the telephone line cord.
• Make sure the AC adaptor is plugged into the base and a wall outlet.
• Disconnect the AC adaptor for a few minutes, then reconnect it.
• Reset the security code by placing the handset back on the base for a few seconds.
The
CHARGE/IN USE
indicator will blink indicating that the phone has been reset.
• The Nickel-Cadmium battery pack may be weak. Charge the battery for a full 15
hours.
• The handset may be too far away from the base.
• Place the base away from appliances or metal objects.
• Reset the security code by placing the handset back on the charging cradle for a
few seconds. The
CHARGE/IN USE
indicator will blink indicating that the phone
has been reset.
Problem
CHARGE/IN USE
indicator
won’t come on when handset
is placed in base.
Weak and/or scratchy sound
Can’t make or receive calls.
Handset doesn’t ring or
receive a page.
If your cordless telephone is not performing to your expectations, please try these simple steps. If you
are still unable to resolve the problems, contact your place of purchase or call SANYO SOS Helpline.
Caution: Do not attempt to service this unit yourself. Servicing must be performed by
qualified personnel.
Troubleshooting
Not all headsets are the same. Some head-
sets may lower volume levels or perform-
ance of the phone.
headset
jack
CLT2410 (SANYO) A5 2nd 7/18/00 6:41 PM Page 9
