5
POWER SUPPLY
AC adaptor
Plug one end of the AC adaptor into the
DC 6V socket, then plug the other end
into an AC outlet.
•
Use only the supplied AC adaptor
•
If the AC adaptor is connected. The
power supply automatically switches
to the AC power source and the in-
stalled batteries are disconnected.
Rechargeable battery
1. Install the rechargeable nickel-cad-
mium battery (SANYO NBP-50A) as
shown below. Observe proper polar-
ity.
C O N T A I N N I C K E L - C A D M I U M
BATTERY. MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
Alkaline batteries
Install two “AA” batteries (not supplied)
as shown below. Observe proper polarity.
Battery recharging or replacement
If the rechargeable battery or alkaline
batteries are weak and discharged,
“
” blinks on the display, then the
power automatically turns off. If this
occurs, recharge the rechargeable bat-
tery or replace the alkaline batteries.
• Dispose of all used batteries safety
and in accordance with all applicable
laws.
Note:
When you are not going to use the unit for
one month or more, take the batteries out
of the battery compartment.
2. Connect the AC adaptor. The battery
is fully charged approximately 10
hours after the AC adaptor is
connected.
•
Do not charge continuously for 24
hours or more.
14
Before use
Check the cassette tape insert slot of
your car stereo. If necessary, change the
direction of the cord on the cassette
shaped pack of the adaptor.
•
There may be some car stereo types
with which this car cassette adaptor
will not work properly.
To change the cord direction
1. Gently pull the cord out of the slot on
the back as shown.
CAR CASSETTE ADAPTOR
2. Change the cord exit location (back
or either side of the pack). Push the
cord back into the slot.
Using in a car
1.
Plug the cord into the LINE OUT
socket.
2.
Insert the pack with “THIS SIDE UP/
HAUT” side up into tape slot of the
car stereo.
LINE OUT
Car Stereo
Car Stereo
or
LINE OUT
CDP-4100CR/AU-final
2/3/05, 10:50 AM
6
